Description
Put an end to slipping protective foils and save valuable time with every single pressing process! The Secabo HeatPlate Cover Holder is the must-have upgrade for your Secabo Heat Press. The constant manual positioning and alignment of the non-stick foil before each print not only costs nerves, but also a lot of time in day-to-day production. With this smart holder, the PTFE film (Teflon film) is fixed permanently, smoothly and securely directly to the heating plate.
Once fitted, the film stays exactly where it belongs. This allows you to concentrate fully on positioning your textiles and transfers - for a smooth, efficient workflow.
The advantages at a glance:
-
Maximum efficiency: No more tedious insertion and alignment of the film for each individual pressing process. Apply the textile, press, done!
-
Optimum protection for the heating plate: The permanently installed PTFE film reliably protects your expensive heating plate from scratches, dirt, toner or adhesive residues.
-
Gentle on textiles & transfers: Prevents transfers from sticking to the heating plate and protects sensitive textiles from direct contact with the metal - for flawless printing results every time.
-
Perfect fit: The holder stretches the film over the heating plate without creases, guaranteeing even heat distribution without unwanted marks.
-
Simple installation: The system can be attached to your existing Secabo press in no time at all and easily removed again if required (e.g. to replace the film).
Compatibility: The HeatPlate Cover Holder for HP7 is universally suitable for all Secabo Heat Presses with heating plates measuring 40 cm x 50 cm
Bank Transfer
